Absolute Power Erupts- New Alpine V-Power Amps at Dealers

Sections: Aftermarket, Car Audio

Print Friendly
For those who haven’t experienced it, there just ain’t nothing like outboard amplification in a car.  As much as the head unit you are using touts it is 40 watts x 4 channels, it is probably doing it at very high distortion rate.  Alpine has been known for both great head units as well as outboard amplification.  And the new V-Power amps crank out the watts without breaking the bank. 
The amps are available in three flavors:
The MRV-M500 offers 500 watts of mono power to drive subwoofers into submission.
The MRV-M250 offers 250 watts of power.
Finally, the MRV-F300 offers 50 watts x 4 to power all of the mids and highs around your ride.  Check out the rest of the release for the rest of the story:
Alpine Electronics Now Shipping New V-Power Amplifiers Popular Amplifiers are Power Dense and Budget Friendly

Alpine Electronics of America, Inc. is now shipping its 2013 V-Power amplifiers.  The popular V-Power amplifiers have consistently been best sellers, and the new models represent the fourth generation of the series.  The amplifiers are known for their reliability, small size, large power output, and friendly prices.  They have been fully redesigned for 2013 and incorporate several new features over the previous models, including:
Smaller, Compact Size:  The new amplifiers have a 40 percent smaller footprint than their predecessors. 

Thermal Performance Stability:  A new, higher efficiency design allows for better thermal management, to help sustain output power and prevent shutdown of the amplifier. 

Dual Feedback Modulation:  Dual internal error correction technology is now implemented on the mono models.  The audio output signal undergoes two cycles of being analyzed and compared to the input signal, and then error correction is applied.  This results in amplifiers with the highest damping factor and lowest distortion in their class. 

4-channel, Non-fading Speaker Input and Pre-Outs:  The V-Power amplifiers can connect to an OEM head unit via speaker-level inputs (up to 10V), making them ideal for an easy factory system upgrade. 

Remote Sensing:  The amplifiers automatically turn on when voltage is detected on speaker-level inputs, eliminating the need to run a separate amplifier turn on wire when upgrading OEM systems.
Power Verification Certificate:  Every V-Power amplifier comes with its own Birth Sheet indicating the actual measured power of the amp. 

Snap on/off Terminal Covers:  The terminal covers easily snap on/off to create a clean, finished look without the need for additional installation tools.
The V-Power amplifiers are now available at authorized Alpine retailers.

Print Friendly